Many of us may not even think about how often we use our water heater. We just go about our daily routine not realizing how much we depend on it. Then we get our utility bill and are shocked by how much it is. These amazing tips for giving your water heater a little tune up just might make that utility bill a little more affordable. You may even be stunned by how easy it is to give your water heater a proper tune up!
Some Water Heater Tune Up Tips Include:
1. Know Exact Location
Your water heater should have a clear access, apart from knowing the exact location of it.2. Give Water Heater Space
Make sure to keep at least 2 feet of space around your water heating system as it needs a good supply of oxygen. If the water heater doesn’t get enough oxygen, it’s efficiency is affected.3. Get To Know Water Heater
You should know the important information about your water heaters, like what type of water heater you have , or whether it’s a tankless type or a storage tank type. You should also keep note the model number, serial number, the age, gallon capacity.
4. Control Temperature Setting
Most technicians recommend setting water heater’s temperature to 120 degrees.5. Check Water Heater Thermostat
The thermostat is the one controlling the transmission of energy to the heating element to create hot water. If the thermostat is not working properly, it reduces hot water. You need to calibrate or replace it.6. Drain Water Heater
Washing out the tank of your system will allow fresh and clean water to run through. This also helps to get rid of the sediment accumulating in the bottom of the water heater tank. These sediments can cause big problems and may even block pipes.7. Know How to Turn Off Water
It is very important to know how to turn off the water and the power supply to the water heater before facing a water heater emergency. The correct power supply should be labeled properly too.8. Check Electric Power Connections
If your water heating system does not produce hot water, check all electric power connections by using a handheld volt meter. You need to tighten all power connections. You may need to replace one or more components if you can’t find any power.9. Install Hot Water Pipes Insulation
Adding an insulation wrap on every pipe leading to and from the water heater pipe is simple and inexpensive.10. Install Hot Water Tank Insulation
Check out your water heater tank, if it feels warm, then you are losing some heat through the tank. You need to put insulation wrap around the tank. This will definitely increase the system’s efficiency.11. Install Hot Water Duct Insulation
All duct joints and seams should be inspected and wrapped using mastic (a special paste) to ensure sufficient hot water flow and to avoid loss of heated water.12. Install Water Softener
Consider putting a water softener on your water heater to get rid of mineral sediments that cause unnecessary wear and tear on your water heating system.
These water heater tune up tips aren't that hard to do and they can really help you save some money. For insistence knowing where your water heater is can help you get to it quickly if there is a problem. If you know what kind of water heater you have, it will be easier for you to get parts that may need to be replaced. You can also install insulation around the pipes and the tank itself to keep the water at the proper temperature. These tips will help your water heater start working better in no time!
For more water heater tune up tips, you can visit:
