If you’re a DIYer or enjoy woodworking projects, then you probably already have the tools you’ll need for this belt clip. The end product is customizable, adjustable and even dishwasher safe! Plus, it frees up your hands and since your water supply is on your body, you won’t have to worry about it spilling or becoming contaminated.

Step 1: Materials & Tools

• Water Bottle,
• #36; 1 3/4“– 2 1/4” or #56; 3” – 4“ Stainless Hose Clamp (depending upon the diameter of the bottle),
• Stainless Fork/Spoon (Not all Stainless is created equal. Find one that does bend, otherwise when you bend the end, it will snap off.) You can use the Handle or Head to make the clip. Knives do not work.

Tools:

• Hack Saw,
• Pliers,
• Hammer,
• File,
• Screw Driver
• Marker.

Step 2: Make the Clip

1) With the Hack Saw remove the Head from Handle of the Fork.

2) Use the File to smooth out the end.

Step 3: Make the Frame

1) Squeeze the Vice Grip Pliers about 3/16 to 1/4 inch from the end of the Handle to make your 1st bend at 90 degrees. Use the Hammer to reach 90 degrees,

2) Measure and mark the Hose Clamp for the 2nd bend,

3) Squeeze the Water Pump Pliers to make your 2nd bend around 170 degrees,

4) Slide the Handle onto the Hose Clamp,

5) Use the Water Pump Pliers to crimp the end, so that the 1st bend is now less than 90 degrees.

Step 4: Add Bottle

1) Use the File to trim the Hose Clamp end so the end will rest inside the Handle,

2) Slide the Hose Clamp around the Water Bottle so that it rests between 1/2 to 3/4 up from the bottom,

3) Twist the Screw Driver to close the Hose Clamp around the Water Bottle,

4) Slide your Water Bottle Belt Clip over your belt to see if it comfortable. If it is not comfortable move the Hose Clamp up or down.

Have you been able to make this water bottle belt clip?

Article & Photo Source: Instructables